Bookmark and Share
Infrared Photogate

Leave comment

My homebrew IR photogate consists of two parts, the emitter and the detector. The emitter contains an infrared LED from Radioshack, and a red LED to indicate when it has power. It uses a lens form an old laser pointer to focus the beam which increases the range by about 10%. The detector uses an infrared phototransistor in series with a 1000 Ohm resistor, and a full wave bridge to make it non-polar. When the beam is unobstructed, it registers pressed in touch sensor mode, and when the beam is blocked it registers released.

Here's a schematic. The emitter is on the right and the detector on the left.



Comments:
Leinardo January 5, 2009, 1:14 am
retroventit.prepys.com
Hey I am going to try this on my microcontroller kit. Thanks for posting this.
seree (from thailand) November 28, 2009, 1:28 am
thank you
Leave comment

Name (optional):

Location (optional):

Website (optional):

Comment:

Characters remaining: 600


Please enter the code that appears in the above image to verify that you are human: